Installing a Brick Paver Walkway or Brick Patio Installation

The usage of Bricks or Pavers to develop a pathway or outdoor patio complements a home in a method that is unequaled. In addition, setting up a Brick or Paver pathway does not necessarily require a pro.

The key to setting up a Brick or Paver Walkway is to very first correctly prepare the area where the bricks/pavers are to be set up. In addition, string lines must be strung on each side of the pathway.
As soon as the location has actually been dug down, 3/4" gravel stone must be laid in and tamped down tightly. The height between the tamped down sand and the stringline should equal the density of the brick or paver.

Now that you have a steady base, put a 1" pipeline or ledger board the length of the sidewalk on either side of the walkway. Using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level surface location to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Install an operate on both sides of the ready area. These strips will function as your walkway border and assistance to keep the integrity and shape of the sidewalk. You can get these plastic strip borders at a lot of home improvement shops. The strips should be anchored down with 12" galvinized nails. You ought to sink these nails into the ground and through the strips every foot.

The secret to laying the bricks/pavers is to guarantee that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will again help preserve the integrity of the walkway.

Inevitably bricks/pavers will require to be cut or split when building the sidewalk. To in fact cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the spot where you desire to break the brick. If your sidewalk has curves you will require to buy/rent a wetsaw.

After setting up the bricks, construct up the outdoors edges with extra sand, and after that shovel in the topsoil and pack down strongly.
Spread stone dust over the new sidewalk and sweep into the fractures. This will finish the interlocking of the bricks and help to remove any weed growth.


In addition, setting up a Brick or Paver pathway does not always need a pro. The secret to installing a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be installed. Now that you have a stable base, position a 1" pipe or journal board the length more info of the walkway on either side of the pathway. These strips will act as your sidewalk border and assistance to preserve the stability and shape of the sidewalk. Inevitably bricks/pavers will need to be cut or split when building the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *